Astracaster First Build FS-1

[Drashkum]

Wow, youve been through the ropes mate. But most of the kits need adjustments, thats just the way things are these days, and fixing them adds to your guitar skills.
So to your question about 2 kits and 2 separarte build diaries, yes that is a must, to avoid confusion. With your glue problems use water, although it can fur up the vaneer, or better still alcohol or thinners to see where the glue marks are first. TAKE YOUR TIME on every aspect of the build, there is no rush, and if you make a mistake and believe me you will, there is always someone here thats been there before and can help you.
Take one step at a time and dont try and do everything at once.
With the staining you can thin out the stain and build up subsequent coats, water based stains are better to work with as they dont dry as fast and you can correct your light or dark patches.
DONT use a furry rag or cloth, use something that wont catch on the grain. you can apply the stain with a brush or rag then gently wipe off with a clean cloth to get the effect you want. You can build up as many coats as you want until you get the desired effect..
It will dry lighter but go darked when applying the finishing coats to seal it.
You can use rattle cans, a brush or spraygun, depends on what you are happiest with. ALWAYS TEST THE CLEAR ON A PIECE OF PREPARED STAINED WOOD FIRST IN CASE YOU GET A REACTION. Then build up mist or thin coats instead of 2 or 3 heavy coats.
I use rattle cans with a handle and apply at least 30-50 coats. I know, over the top but thats just me. If you leave coats for longer than a day or so, finely sand between coats or it may laminate.
Most of the guys on here can add to this but this is just painting 101. All the best with your build..

Rolls would work, but are probably overkill. In my case I bought a small sheet of the cheapest light colored veneer I could find on eBay, which happened to be anigre wood. I still have most of it. I've used it to fill gaps, make wedge shaped and flat shims...and most recently to fill the the fret slots after turning a fretted bass into a fretless.




I got a piece that was about 1x2 feet that is turning out to be a lifetime supply ;-)

Cut it to size (slightly large) with scissors, glue in, and sand off any excess.

Thank Simon for the idea...he turned me on to it.

You can get something that matches your guitar wood too. Or you can get sampler packs with a variety of woods. I use it in places that don't show so it doesn't matter much, but anigre turns out to look a lot like maple, and takes glue well, so it might work for you, and it's quite cheap (which always appeals to me).

https://youtu.be/k-8P-P4JtzQ

One of my friend who owns a timber business gave me this catalogue of mini veneer sheets which he doesn't use anymore. It containers small paper thin veneer sheets of various woods totally 144 in number. Some are dyed and some are natural. These veneer sheets are 0.68mm thick and are 13 cm x 10 cm size. Do u think I can use this and fill up the gap. The wood I used previously from spoon was 1.64 mm. So i may need 3 of these strips to be glued.

How to go about it? Can you brief me a step by step guide or can you refer me to a video please? How do u make a wedge out of them?

Thank you
Drashkum



Sent from my NE2211 using Tapatalk