It’s been a long time since I have done any builds, but I think I have time to get stuck into this build. Not really sure what to do with regards to finish on this one so any suggestions are welcome.





A couple of issues to get over to start with.
I was thinking about staining the back but I seem to have gotten unlucky with the 3rd piece of wood used on the jack end of the body



This could stick out like a sore thumb if I just stain the back and sides. As much as I don’t want to grain fill and do a solid colour nitro finish on the back and sides this may make me have to consider it.



This is also another reason to do a solid colour. I will try to glue and clamp first rather than fill and spray a solid colour over it. Annoying as I love the grain on the ash overall.


Sent from my iPhone using Tapatalk