PSH-1 Build

[McCreed]

...and once done will spray a few layers of Polyurethane in a spray can on the body and neck separately, then will apply wipe on poly to build the layers, I don’t think I need to worry about the bindings at this stage as I’m using a gloss clear poly as a top coat. After this, I will then glue in the neck.

When you spray the poly, just be sure mask off the neck pocket and heel where they will mate when the neck is inserted. You want the glue adhering to bare timber on both faces.

[vivek_rc]

When you spray the poly, just be sure mask off the neck pocket and heel where they will mate when the neck is inserted. You want the glue adhering to bare timber on both faces.

Thank Mccreed , Definitely going to tape then up as well as the fret board etc.

while on the topic, I got two shims I’d need to fit in the pocket, my thoughts are to glue them in & clamp down one by one leaving 24 hours between each shim to set.

then glue in the neck.

[mrpearson]

Thank Mccreed , Definitely going to tape then up as well as the fret board etc.

while on the topic, I got two shims I’d need to fit in the pocket, my thoughts are to glue them in & clamp down one by one leaving 24 hours between each shim to set.

then glue in the neck.

That’s what I did. Glued my shim and left clamped for 24 hrs. It was a few more days before I set the neck.


Sent from my iPhone using Tapatalk