PSH-1 Build

[Simon Barden]

Yes, that looks fine. The nut slots are too high for a low action, but cut them lower (or sand the bottom of the nut instead) and that height will come right down.

Looks like you'll be able to get a really nice low set-up on it (if that's your preference).

[vivek_rc]

Yes, that looks fine. The nut slots are too high for a low action, but cut them lower (or sand the bottom of the nut instead) and that height will come right down.

Looks like you'll be able to get a really nice low set-up on it (if that's your preference).

Thanks Simon, I actually ordered a Bone nut with the kit, never swapped out a nut before so will be YouTubeing it on how to replace a nut. Will compare the two and adjust the bone nut height accordingly by sanding the bottom as suggested

Also do you have a suggestion as to how I can mark out my neck alignment while it’s clamped down now so that when I glue it and then clamp down, I have a guide to ensure it’s the same angle. Was thinking of drawing a line either side of the neck along the section where the neck and top of the veneer meet within the pocket area?


Sent from my iPhone using Tapatalk