The new item on the agenda.

[WeirdBits]

I tend to leave the legs long (so I can position it and/or reuse it elsewhere), and cover them with heat shrink or insulation stripped off wires:



If you’re going with the single PIO cap with two tone pots just have the ‘out’ from tone 2 link to the ‘out’ of tone 1 and have the cap go from there to a ground point.

[ozzbike]

I tend to leave the legs long (so I can position it and/or reuse it elsewhere), and cover them with heat shrink or insulation stripped off wires:



If you’re going with the single PIO cap with two tone pots just have the ‘out’ from tone 2 link to the ‘out’ of tone 1 and have the cap go from there to a ground point.

I am using the wiring diagram from Seymour Duncan....3 single coil 2 tone push pull volume for bridge and 5 way crl blade switch.

I can't upload that diagram...too big.....but it is here.

https://docs.google.com/gview?embedd...1VppENB_2T.pdf

I was intending to solder it like the one in this photo. If I understand you, then this is what you meant.

Once again weirdy. Thanks.