Been a while since I have had time to get back to this ...re build.



So I have filled all the ash grain as much as I could with wood filler. It’s all been primed and sanded as flat as I’m willing to put time into.




I had never tried stripes before so tried to measure everything out as precise as I could and put the lines out



Happy enough for a first attempt at it. There is some blue bleeding into the cream lines and there is that “tide line” there too. Anyone any advice on how to clean it up a bit? Or is it one of those things that is gona cause more hassle than it’s worth?
Regardless of the slight bleeding I am going to spray the cream lines with a few coats of lacquer first, and then go for the whole body.


Sent from my iPhone using Tapatalk