Couple of updates from the weekend. A glamour shot of the plugged & redrilled bridge post holes:
And the relocated bridge tone pot
Bridge ground wire is in.
And I drifted in the vintage-spec extra long steel anchors. First bit of hardware attached, I’m unreasonably excited by this.
Some more masking and the first light coat of primer. From my test sprays with the Rustoleum metallic it shows every surface imperfection so there’s a lot of work to do here - eg the mark between the pickup routs where I dropped something on it.
So spraying metallic out of a rattle can has knobs on it. I've probably done about 30 coats all up, with substantial rubbing back on several occasions. The best technique I found was basically multiple light mist coats applied a few minutes apart in a single swirly pass as the bugger likes to spatter at inopportune moments.
My $15 jewellers saw finally arrived from China so next step was cutting the MOP inlay. I looked into the logo font option, I think I saw someone selling one online, but ended up designing it myself in Sketch. If anyone would like a copy of the vector file let me know & I'll post it.
This is time-consuming and is very nerve-wracking/concentration-intensive, probably like being an english batsman at the MCG
Finished product, it’s not perfect but I'm pretty happy with it. Next step routing.
Looking great! And still seemingly on track with your deadline
Nice work. Might have to hunt down a cheap jeweller's saw myself...
Sent from my Pixel 4 using Tapatalk
Kit builds: JBA-4M | STA-1M | AIB-1Q | TL-1 (in progress)
Side projects: Artist TC59 | Sheoak Dreaming | Spalted Marri Metal | Randy Vs | Sassafrassin' | St. Vincent
BD - here’s hoping I can argue that MOST of it was done in '21
We English are used to disappointment and despair at our cricket team’s results. It’s the occasional slight glimmer of hope we can’t cope with.
30 coats of paint must have meant quite a few tins of paint. Really worth thinking about investing in a small compressor and a mini-spray gun if you ever do something similar. The chances of getting paint blobs with one are very small indeed compared to using rattle cans.
Nice inlay work!
Setting up for routing with the Dremel attachment. It was less precarious than it looked.
The depth limiter on the Dremel router is complete rubbish though, best results were routing it in stages and just locking the bit down a little bit further each time. I gave up on any prospect of a neat fit and just hacked out a 1950s-esque large recess that I'll fill.
Removed the plastic nut and found it was glued on harder than it should have been, so I tore a couple of small chunks out of the headstock. I did some repair work/grain-fill with timbermate and stained the mahogany (although I'm going to paint anyway).