yeah sounds good Barge. If you are only using one router bit how did you route the 6mm deep bridge cavity ? Use a thicker template ?
thats presuming the bearing is ontop of the bit.
Tune in folks the Barge and Woks show is currently airing
yeah sounds good Barge. If you are only using one router bit how did you route the 6mm deep bridge cavity ? Use a thicker template ?
thats presuming the bearing is ontop of the bit.
Tune in folks the Barge and Woks show is currently airing
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Posting Permissions
