PSH-1 Build

[vivek_rc]

Hi All,

Back at it again,

I’ve been applying layers of shellac on the back of the body and neck, it’s a blond shellac with some burgundy Angelus dye mixed in. So far it’s coming up pretty nice.





I’ve placed the neck into the body and the fit is pretty snug and I can see that at the neck heel it is not sitting flushed on the base the pocket, picture below.






Any advice on how to fix it or if it needs to be fixed? Do I sand the walls of the pocket to try and get it to sit flat?

[mrpearson]

Hi All,

Back at it again,

I’ve been applying layers of shellac on the back of the body and neck, it’s a blond shellac with some burgundy Angelus dye mixed in. So far it’s coming up pretty nice.





I’ve placed the neck into the body and the fit is pretty snug and I can see that at the neck heel it is not sitting flushed on the base the pocket, picture below.






Any advice on how to fix it or if it needs to be fixed? Do I sand the walls of the pocket to try and get it to sit flat?

Hi - mine was the same. How is your action height as I had to make a shim to sort


Sent from my iPhone using Tapatalk

[vivek_rc]

Hi - mine was the same. How is your action height as I had to make a shim to sort


Sent from my iPhone using Tapatalk

Haven’t done that, was wondering how I would remove the bushings after putting them in to check the string action, then came across this video

https://youtu.be/ykWHdRypMUM