Build #6 - TLA-1

[FaustoB]

Neat work Trevor!
Body and headstock are looking great!

can I ask you how did you find using the inkjet waterslide decal paper? Was it a headache? or relatively straight forward to print and apply? It looks amazing.

[Trevor Davies]

Neat work Trevor!
Body and headstock are looking great!

can I ask you how did you find using the inkjet waterslide decal paper? Was it a headache? or relatively straight forward to print and apply? It looks amazing.

Hi FaustoB,
The waterslide decal paper was relatively straight forward. I print my logo onto paper first to check for size and position. Then tape some decal paper over the logo area of the paper and then reprint. Then I added a few layers of truoil to the decal paper. Cut out the logo with a minimum clear edge. Add it to water for a few minutes. Carefully slide it on and position it (it is easy to damage the decal here as it is very fragile). Sponge dry the logo to remove moisture and air bubbles. Note - I normally do 2 Logos at a time in case I stuff up.

I have also found the packing tape method with a laser printer works well (but the decal paper is better). You just have to be careful when rubbing off the paper backing to ensure all the backing is removed, and that the image is not rubbed off. The tape is thicker and therefore harder to bury under the finish.

I am now using vinyl stickers.