New dowel plug for the end of the truss rod in.
Skunk stripe in
Stripe trimmed, will finish sanding when I'm ready to do the finishing.
Fretboard glued on. Crossing all my fingers it's on straight, was a bit of a bugger to line up and clamp.
New dowel plug for the end of the truss rod in.
Skunk stripe in
Stripe trimmed, will finish sanding when I'm ready to do the finishing.
Fretboard glued on. Crossing all my fingers it's on straight, was a bit of a bugger to line up and clamp.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
If it's not, just say its a fan fret neck.Originally Posted by Sonic Mountain
All good stuff.
Hah, well good news, it seems OK. Bit messy but nothing a good clean up and refinish shouldn't sort out. I think its going to work.
Truss rod adjusts fine. Fingers crossed. I'll give it a good clean up and then assemble it to see how it goes before I spend any time on redoing the finish.
Build 1 - Shoegazer MK1 JMA-1
Build 2 - The Relliecaster TL-1
Build 3 - The Black Cherry SG AG-1
Build 4 - The Sonicaster TL-1ish
Build 5 - The Steampunker Bass YB-4
Build 6 - The Howling Gowing ST-1
"What I lack in talent I make up for with enthusiasm"
Posting Permissions
Reply With Quote