Time to get the dots in
BTW these are 6mm dots, measure existing dots carefully before ordering them and get a few extras incase you drop one.....
Dots lined up and ready to go
Take a small file and round the back edges off a bit
Then a drop of CA glue into the dot hole. Push the dot in using the back of a centre punch. Dot should sit slightly proud of the fretboard and level as possible. You can see the difference in colour with MOP vs plastic dot here
Wipe any excess CA glue away quickly with a cloth
Repeat above. All in place! I’ll wait for the glue to cure before starting on the process of shaving the dots flush with fretboard using a blade
Sent from my iPhone using Tapatalk Pro
Reply With Quote