DTL-1SB First build

[Trevor Davies]

The checking continues so I have another few questions please before I begin.

1. The pots with 2 x 2 different nuts and washers. I assume the washer goes over the pickguard then the smaller nut then tightens down before adding the control knobs. But where does the bigger loose fitting nut go? Between pickguard and pot?
   
   
2. To attach the 3 way switch should I be using the wood screw in picture - all the after market switches seem to have mini bolt?
   
   
3. Finaly should I stick with the pic guard on my first build I can get it aligned with the bridge, neck pup and control cavities with only a small shave off the LHS of where it sits next to the neck circled - any traps with this approach?
   

Thanks again

Hi Dean,

for 1) - yes. The lower nut allows for adjustment of the height of the pot on the pickguard material.
2) - I would not think a wood screw would work, I would have expected a bolt. Others may know more about this!
3) - I think a small shave would be fine. I have sanded (and filed, scraped) guards around the neck edges to get a good fit. With sanding I normally use paper around a block of wood to keep a straight edge. Take it easy, and keep checking to ensure you do not take off too much.