Checking the controls fit and all the bits are in the box
The checking continues so I have another few questions please before I begin.
The pots with 2 x 2 different nuts and washers. I assume the washer goes over the pickguard then the smaller nut then tightens down before adding the control knobs. But where does the bigger loose fitting nut go? Between pickguard and pot?
To attach the 3 way switch should I be using the wood screw in picture - all the after market switches seem to have machine screw?
Finaly should I stick with the pic guard on my first build I can get it aligned with the bridge, neck pup and control cavities with only a small shave off the LHS of where it sits next to the neck circled - any traps with this approach?
Reply With Quote
