Hi Fipsy.
Sounds like it was an oversight at the factory. There definitely should have been holes bored from neck p/u cavity to the bridge p/u cavity and bridge p/u cavity to the control cavity. Must have been a Friday arvo or Monday morning production.
I would first contact Adam and get his advice. He's very good at replacing parts that aren't right.
This a problem that can be remedied DIY, but it being your first build, you may not have the tools or experience to carry it out yourself.
However if you are game, the hole from the neck p/u cavity to the bridge p/u cavity requires a long auger bit which is drilled straight through the neck pocket all the way to the bridge cavity. I would recommend a 6 - 6.5mm bit.
If you use the bottom of the pocket as a guide (ie: rest the bit along the bottom) you can keep it pretty parallel to the plane of the body and not poke out through the front or the back. (definitely want to avoid that!)
The bridge to control cavity is a little trickier because it needs to be done on an angle. With the small size of the bridge p/u cavity you just need to be somewhat careful not to hog out the edge of the cavity routing with the auger bit resting on the edge. It's a good idea to keep a piece of cardboard or thin ply between the bit and the body to prevent this.
If it gets buggered up a little, it's not the end of the world as the tele bridge plate will cover it to a certain degree. Of course we always want to try and do the cleanest job we can.
See what Adam says and let the group know if we can be of anymore help!
Cheers,
Mick