good stuff Andy. Those micro mesh pads you will love. Go through all the grits, as long as you built up enough clear coats.
I think the bone shim might look better than a non matching piece of rosewood. You could glue the shim in place, let it dry, then glue the bone nut once you have set the height etc
So is the ash tele your third PBG build ? your rate of GAS is increasing exponentially hahah
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Tell me about it! I showed my wife the exceptional blue hollow bodies that have been on the forum lately...gotta start the sell early!Originally Posted by wokkaboy
Build #1 - ST-1 - Completed
Build #2 - LP-1SS - Completed
Build #3 - TLA-1R - Completed
Build #4 - SGD-612 - Completed
Build #5 - ES-1G - Completed
Build #6 - STA-1HT | Completed
Build #7 - ST1JR - Completed
Current Build #8 - JBA-4
Build #9 - Semi-scratch build Tele x 2 - Completed
Current Build #10 - PRS-1H
Current Build #11 - AGJR-1 - Completed
Current Build #12 - ATL-1SB
Current Build #13 - GST-1
Current Build #14 - FBM-1
Posting Permissions
Reply With Quote