Hi Ivo.Originally Posted by Ivo Kalis
So if I follow you correctly:
- use the black wire from the neck pickup instead as the blue in the diagram
-green+screen from neck pickup is signal ground on the first potentiometer
-use black wire from the bridge pickup instead of the red on the diagram
-green+screen from bridge pickup as signal ground for second potentiometer
-tape up red/white wires
-Use rest of diagram
But how to make ground with the bridge? there is no internal hole to get there?
Yes, for the wiring. Just to be sure - each red/white wire is taped up separately.
For the ground to the bridge - My kit had a small hole drilled from the bridge post hole closest to the control cavity. In the cavity, this hole was very close to the jack socket hole. Hopefully your kit has this predrilled, but if not, it should not to too hard to drill.
Reply With Quote