fender3x - this is where I was getting confused actually, in the wiring diagram it's got wires coming off the bottom tone pot - however in my case every wire that I needed to solder came off the volume pot. I'm a little clueless on electronics so I assumed that it didn't matter as long as it was connected to some pot.
So in regards to the picture of the volume pot you've posted, the first lug (reading from left to right) has a red wire going from it to the 5 way switch. The second lug has a yellow wire going from it to the output jack, and the third lug has been bent upwards on to the volume pot and has 3 wires soldered on to it - a yellow that goes to the adjacent tone pot, and two black wires which I have soldered to the bridge and output jack. Let me know if that sounds off.
Here's a slightly better picture and one of the back:
Reply With Quote