PSH-1 Build

[vivek_rc]

Cutout my Shim from a 2mm thick maple veneer. Does it look ok?

Understand Simons instructions and also saw a YouTube video from Crimson guitars that describes the process.

Only question is my veneer is 2mm, so once I sand it down it would be 2mm on the high side, would that be too high? I could sand the veneer flat till I get approx 1 mm.





Sent from my iPhone using Tapatalk

[mrpearson]

Cutout my Shim from a 2mm thick maple veneer. Does it look ok?

Understand Simons instructions and also saw a YouTube video from Crimson guitars that describes the process.

Only question is my veneer is 2mm, so once I sand it down it would be 2mm on the high side, would that be too high? I could sand the veneer flat till I get approx 1 mm.





Sent from my iPhone using Tapatalk

Hi - my thick end was 1.5mm. I would recommend aiming for 2mm assuming your neck is the same as mine. Will give you a fraction more adjustment if you want a super low action. At 1.5mm and with a lower nut I reckon I should be fine. Give me 24hrs and I plan to install the bridge posts and check to see whether I have been successful.


Sent from my iPhone using Tapatalk

[vivek_rc]

Hi - my thick end was 1.5mm. I would recommend aiming for 2mm assuming your neck is the same as mine. Will give you a fraction more adjustment if you want a super low action. At 1.5mm and with a lower nut I reckon I should be fine. Give me 24hrs and I plan to install the bridge posts and check to see whether I have been successful.


Sent from my iPhone using Tapatalk

Thanks mate, good luck!