Build - TL-1

[McCreed]

Hah! 7 minutes too late, but it seems Trevor and I are on the same page!

[vivek_rc]

Hah! 7 minutes too late, but it seems Trevor and I are on the same page!

Hey Trevor, McCeed

Thanks for the advice, and it was just in time.

I’m actually planning to use a Dingotone butterscotch finish on the body and I just had a look at the instructions, and yup they say to go to 240. I got a bit carried away with the sanding. Will go over the body again with 240.

Also been reading about getting rid of the raised grain, which will come up when I start to stain. Is it ok to wipe the body down and neck with a wet rag and get rig of the raised grain with 0000 steel wool or should I use denatured alcohol? Or is there a better method? Or don’t bother?

Thanks