A bit later on today, I'm going to remove the front speaker grill from the Peavey 410TX bass cab so I can remove one of the speakers so I can have a good look at it, while I'm at it, I'll grab my tape measure and measure the outside dimensions of the cab itself, will also post some pics of the back panel as well.
@ Marcel No worries at all mate.
I should add that I'm mainly interested in using the bass cab for bass guitar amplification purposes, I compared the circuit diagram for my Fender Super Twin amp with the one for the Fender Super Bass amp, and to all intents and purposes they are practically the same with some very minor component differences, and from my experience the Super Twin seems to work fine if used as a bass amp, interestingly, when Fender released the original 4 X 10 Tweed Bassman, it was originally intended as a bass guitar amplifier, guitarists soon learnt that it also worked great as a guitar amp, and was used as a design reference by Marshall for the design of their first Marshall JTM45 amplifiers back in 1962 or so.
Okay, here we go, the outside dimensions of the Peavey 410TX bass cab are as follows:
Width = 615mm.
Depth = 435mm.
Height = 625mm.
All the speakers are indeed 10 inch in diameter, the cab itself seems to be made out of 20mm particle board, or, it could be 20mm plywood, hard to tell.
Some more pics of the cab:
Last edited by DrNomis_44; 16-11-2020 at 12:13 PM.
Reply With Quote