Aion Electronics Aurora Pedal

[Woltz]

You can see in my Phase 45 thread I made a enclosure jig out of thin MDF. I drilled holes using the enclosure template. It helps hold things steady but also lets me test the template itself - are the pots close but not too close etc.

Yep I might do that. I must've missed that in your thread.

Sent from my SM-G960F using Tapatalk

[jugglindan]

Yep I might do that. I must've missed that in your thread.

Sent from my SM-G960F using Tapatalk

Just don't make my mistake. My DC jacks have the thread on the inside of the case, so they need to be soldered into the enclosure with the nut already threaded over the wires. I completely forgot this last night and soldered the jack into the MDF! So I had to cut it off after testing. Still need to clean up the solder so I can box the circuit. Fortunately I have enough length on the wires so I don't need to change anything else.