Tla-1

[glenwilliam]

Now time for the infamous bridge positioning. I measured a few times, and I think I have come across the same issue as most people in that the hole for the bridge pickup is just a little too far back:


I also noticed that the pickguard is a little off - it doesn't sit around the neck completely straight so i'm going to have to trim a little off the inside.. nothing major, maybe half a mm.



I picked up a little Ozito rotary tool from Bunningtons this morning as recommended by a couple of people here so looking forward to getting that out and giving it a burl this afternoon! Wish me luck!

[king casey]

I picked up a little Ozito rotary tool from Bunningtons this morning as recommended by a couple of people here so looking forward to getting that out and giving it a burl this afternoon! Wish me luck!

Should be ready for anything then. I've had mine for a couple of years now and it gets regular use.
Out-lasted the Dremel that it replaced (of course you can use Dremel attachments in it).
You'll get better and better with practice.

cheers, Mark.