There has been some progress with this one. Made a template for the shaped piece for the headstock and used that to make a piece out of mirrored acrylic, the thinking being it wouldn't weigh much.
Once the lettering was applied it became obvious the acrylic wasn't going to do the job.
Started again using aluminium, polished as well as I could get it,
then applied the lettering. (The only pic I have left of the template coz the phone decided to delete almost all pics on it. May have been dropped one too may times in its past..maybe)
New bit in place
and comparison showing why the first one wasn't going to work well.
Wiring is mostly done, did have to get more push back wire as underestimated how much would be needed.
Getting closer.
Grant
Reply With Quote