Results 1 to 10 of 105

Thread: Christodav's JTL-1 Offset tel

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member christodav's Avatar
    Join Date
    Dec 2016
    Location
    Melbourne Australia
    Posts
    262
    I will leave the neck alone.

    Hmm. I work in a tool shop so getting the tools is not an issue. I could use the larger router trimmer base that Makita make. I think that may just work. The more I think about it, the more I realize that it's not a huge task really. It's just scary thinking about what could go wrong LOL.
    I was probably going to take the neck off again anyway to set it up.

    All good

  2. Liked by: Bakersdozen

  3. #2
    Quote Originally Posted by christodav View Post
    I will leave the neck alone.

    Hmm. I work in a tool shop so getting the tools is not an issue. I could use the larger router trimmer base that Makita make. I think that may just work. The more I think about it, the more I realize that it's not a huge task really. It's just scary thinking about what could go wrong LOL.
    I was probably going to take the neck off again anyway to set it up.

    All good
    Sounds good. Your well situated then. Just be careful where the treble side of the neck pocket side curves down .. very easy to tear out that bit. I think that was my biggest stress as there is enough to form a template in the rest of the pocket bar that little bit. That's where I added a horizontal part to my guide to make sure I didn't breach that area. You could easily just clamp a rail to the side if you fabricated it properly.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •