Results 1 to 10 of 164

Thread: Woltz's semi-scratch strat build

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #11
    GAStronomist FrankenWashie's Avatar
    Join Date
    Jan 2016
    Location
    Glebe, NSW
    Posts
    5,666
    Bloody Hell! It’s concerning that it got thrown so forcefully, potentially it could have been straight at you or flicked up into your face with the router following it. I hope (wounded pride and bruised luthier enthusiasm aside) that you weren’t hurt


    A few question on the incident:
    Was that on a router table or were you using that Schmick Triton shown earlier?
    how did you clamp it down?
    were you heading forwards up that curve on the bout or down to the rear of the body?
    What is the direction of rotation for the router?
    Are you using a standard 2flute cutter or a spiral type 3 or four flute bit?

    it looks like you were a fair ways down the body side on that cut when it grabbed, how deep a cut were you on?

    Edit: I just back tracked the thread, The body blank being Tas Oak may not be helping the grabby grabby on the router bits. Vic Ash does similar things, but I’ve had good results with Plantation Mahogany and Qld Maple.
    Last edited by FrankenWashie; 11-06-2019 at 08:22 PM.
    FrankenLab
    Hand crafting guitars, because Death Rays are expensive.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •