Quote Originally Posted by FrankenWashie View Post
I would lay some 120 grit paper across the area the ring fits on, secure it and then GENTLY rub the pup ring neck to bridge to try and match the curve.
I did this on an LP build and got the profile sitting perfectly. ON the bridge ring i used a profile gauge to recreate the curve of the body on the respective sides of the pup ring, then trimmed with a dremel and used 220 paper for the final clean up of the curve.
It's a bit fiddly but can provide good results if you are careful with your placement and keep your strokes and pressure even.
Absolutely brilliant idea/advice FW thank you. This will be a perfect solution for the back of the neck ring. I think the front should be fine once the neck is in.