sounds good Doc I think both those options sound great
wow just had a quick look at the website, looks like so many parts and speakers available, you will be a kid in a lolly shop Doc !
sounds good Doc I think both those options sound great
wow just had a quick look at the website, looks like so many parts and speakers available, you will be a kid in a lolly shop Doc !
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
I reckon....lol...I might look into ordering some Valves from amplifiedparts.com soon, my stash of 12AX7 valves is getting a bit low and there are a few sick ones amongst the good ones, might also order a set of four JJ EL34 Valves for my Marshall MA100C amp too.
So far, out of all the speaker models I've checked out, I'm liking these Celestion G12K-100 Speakers the most, the pricing is well within my budget since two of them will cost roughly $280.00, if I connect two of them in parallel I'll end up with a 4 Ohm 200W 2 X 12 speaker cab:
https://www.amplifiedparts.com/products/P-A-G12K-100
Or, I could buy a couple of these Eminence Patriot 12 Swamp Thangs:
https://www.amplifiedparts.com/produ...A-SWAMPTHANG-X
I'm also liking the tone of these Jensen Vintage Ceramic 12 C12K 100 W speakers too:
https://www.amplifiedparts.com/products/P-A-C12K
Going back to Celestions again, these 12 Inch Celestion Seventy 80's look interesting:
https://www.amplifiedparts.com/products/P-A-70-80
Last edited by DrNomis_44; 24-06-2016 at 10:57 AM.