Since I had to pick up some electronics bit and pieces for the Varitone build, I decided I would get some bits to have a go at a treble bleed circuit. I decided to mount some treble bleed circuits to some alligator clips and make a treble bleed tester kit.
Researching online, there are a lot of different value resistors and capacitors used.
I have created:
1. 110 k resistor with a 1 nF capacitor.
2. 150 k with 1 nF
3. 220 k with 1 nF
4. 150 k with 2 nF
&5. 220 k with 2 nF.
Now I just have to test them and play.
Has anyone on the forum tried any of these, or have any other suggestions?
Reply With Quote