Hi All, I've gone and stripped the head of the direct mount pickup screw and now can't remove it. The reason I need to remove is that is was the only one out of the 4 screws that for some reason would not go all the way in, even though I pre-drilled to the same depth.
I've tried using duct tape on the head to help fill the gap, tried using 2 different nose pliers and even looked at cutting the head for a flat head screw driver using my Dremel, but the blades are too thick.
So annoyed as i was up to the soldering and setup prior to completion!!!!
Any ideas how to get this out without damaging the body or the pickup or the pre-drilled hole???
Reply With Quote