Hey Fatboy,
Thanks! I hope it still looks good when I do the nitro. My process so far is that I used 1/4 tsp of brown Keda dye in 5oz of isopropyl rubbing alcohol and 1oz of hot water. I used a cut up t-shirt to apply the brown dye to the veneer. It dries quick and about 15 mins later I very lightly sanded the super thin veneer until it lighted up a bit. I didn’t sand much at all. A few hours later, I used 1/4 tsp of yellow Keda dye in 7oz of rubbing alcohol and 1oz of hot water (a little more dilute than the brown). I used a new clean t-shirt to apply the yellow. I did not wipe or sand it off. That is it! Next, I plan to use black lacquer to paint the burst and the sides and back. After that I will spray with Mohawk Clear Stringed Instrument lacquer.