I've been doing some research on wiring up the controls and pick-ups, and came across this LP DIY build that does things very different from the videos Adam has on his website.
One thing I noticed in that video that is very misleading (especially without any clarification) is the statement (at 4:16) that a B taper is for the volume and A taper is for the tone.
To match the change in output level to the way the human ear responds to changes in sound levels, a volume pot should have a 'logarithmic', log' or 'audio' taper, whilst the tone control is often picked as having a 'linear' or 'lin' taper, though both linear and logarithmic pots can be used for a tone control function - it's down to personal preference as to how quickly you want the treble to roll off.
But not all manufacturers mark their pots in the same way and while it is now common for a pot marked with an A to have a log taper and those marked with a B to have a linear taper. Some time ago (not sure how long) this used to be reversed, (so A was linear and B was log) but this then got swapped. Not confusing at all!
So it's worth checking out the details on the manufacturer's web sites just to be sure.
If you look at the CTS data sheet for the range of pots that are commonly used in guitars
http://www.ctscorp.com/wp-content/uploads/2015/11/Series-450G.pdf, you'll find a range of different response curves, with both A and B being log type pots (as well as types C, BD, H and J) and D being linear. Luckily they use a numerical code in their part number for the taper type (so you won't get easily confused), and when sold by 3rd parties are generally listed by a generic 'audio' or 'linear' taper description.
Bourns pots use A for Audio, B for Linear and C for Reverse Logarithmic (often used in left-handed guitars).
Alpha pots use use A for Audio, B for Linear and C for reverse logarithmic, (though some of their linear taper curves are rather fast-acting for use as tone pots).
http://alphapotentiometers.net/html/taper_curves.html.
So if you've got some name-brand pots and want to check on the taper type (if it's not stamped or printed on the pot), it's normally easy to look up the manufacturer's website and find out the specific taper your pots have. But if you've got some generic no-name pots that have A and B markings on them, it's probably worth getting out the multimeter (anyone putting together an electric guitar needs one) and checking the resistance between one of the two end tabs (connected to each end of the potentiometer's resistance track) and the central tab (connected to the wiper) when the shaft is set to the half-way position.
A Linear pot will have a value close to 50% of that of the pot's maximum value, so 125k ohms for a 250k ohm pot, and 250k ohms for a 500k ohm pot. A Log pot will typically have either a value of around either 10% or 90% of the pot's maximum value (depending on which end tab of the pot you're measuring - you can easily swap to read between the centre tab and the other end tab to make doubly certain if you've got a high resistance reading to start with), so 25K or 225k for a 250k log pot and 50k or 450k for a 500k log pot. there may be some variation on this if it's of a slightly different curve type, but it certainly won't be 50% of the pot's value.
So
A normally means Audio/Log (and is meant to be used as a volume control) and
B normally means Linear (and is meant to be used as a tone control),
but not always (and videos like the one above don't help)!