Attention Of Db Not All Gibson Headstocks Break Sometimes Its The Tailpiece

kimball492

Well-known member
This fortunate guy only broke his tailpiece when dropping his Gibson 335
 

Attachments

  • image.jpg
    image.jpg
    37.6 KB · Views: 221
Last edited:
Whoa!
Never seen that one happen before..
Headstock, check.
Neck at heel, check.
Tuners, check.
Lower horn, check.
And now tailpiece......
I agree with Fretty, that could only be the result of a fault in the casting.....
 
Must of been , mind you when I cast sometimes porosity marks small ones on the surface when you start to clean them out theres a massive hole underneath your totally unaware of which has to be filled . I'm sure they must do the same ref bridges stop pieces
 
Dunno, Kimball... I would assume that with hard metal castings they would ditch them if they had visible faults..
My money would be on a carbon inclusion being present internally, invisible until the casting fails.
If this Guitar is a fairly recent model the casting would have been made in China... Our Chinese friends are still a bit behind the pace with quality control on casting and steel making..
 
Yep, that happened to my Epi right after my LP kit was finished... Still yet to actually get a new bridge...
 
Back
Top