I needed to find a set of pickups to put in my HotRod Strat because I didn't have anything useable amongst my bits and pieces, so, I went to my local Cash Converters store to see if they had anything that had a bridge humbucker, middle single-coil, and neck single-coil pickup configuration that I could buy to use for parts, they had an Eston Superstrat in stock which had the pickups I needed, and costed me only $160.00, so I bought it and installed the pickups from it in my HotRod Strat, turned out they all worked, anyway, I was thinking about what I could do with the body when I decided to see if my 22 Fret Maple Strat Neck, which I was going to use on my Gold Strat, would fit in the neck pocket of the Eston body, surprisingly, it fitted perfectly, all I needed to do was to dowel the existing mounting-screw holes in the neck, and then drill new ones in order to install it on the Eston body, I also tried seeing if the Gold Strat scratchplate would fit the body and it turned out that it would, the existing mounting-screw holes will need to be doweled, but that's fine, I even managed to find a Chrome Strat Bridge I could use, I can also use the existing springs and spring claw as well, so, I'm shelving the Gold Strat project for the time being, but will come back to it later on, meanwhile, I'm going to make a Strat out of the Eston body, I pretty much have all I need except for three 250k CTS Pots, and a 0.1uF Tone Cap.

I'll post a pic of the Eston body later on for you, stay tuned.