Es2v

[Stu]

Building a ES2V electric and was saved by the plastic tubing idea but have two questions. How do I earth to bridge? I have put both posts in and did note note a hole for wire access, is there one and if not how do I earth it. Second question is the timber saddle glued in place or just held by string pressure. Thanks for any advice Cheers Stu

[dingobass]

Hey Stu.
These ones are earthed via the trapeze so all you need is to drill a small hole under the hinged bit and feed a wire through.
The bridge is a floater. You will need to match the profile to the b ody by placing a piece of sandpaper grit side up on the body and sanding the bridge to suit.

[dingobass]

Edit... stoopid here has the wrong kit in mind....
You will need to drill a hole back from the post hole to the cavity.......