Glued neck in. big problems

[Aidan7250]

Hi, i just glued the neck in, all the notes cut out from the 5th upwards. i have tryed the truss rod, no use. any ideas?

[stan]

Hi Aidan.
What method did you use, how did you do it?
What type of kit?
Can you post some pics, they always help

[Aidan7250]

I dont know how i tryed and it wouldnt let me post pictures. Haha, i have an EX-1 i just clamped it down with titebond glue

[keloooe]

Hi Aiden, maybe the frets are not flat. Try making a small tool that allows you to check the frets, three at a time, like this tool here: http://www.stewmac.com/Luthier_Tools...et_Rocker.html

Also make sure the bridge is not too low, pics always help too!

[wokkaboy]

Hi Aiden we need more information and photo would help. Have you tried raising the bridge saddles ?
If the neck wasn't seated properly when you glued it, it may be sitting a little too high hence strings bottoming out on the higher frets.
Has the nut been changed could be too low ?

[wokkaboy]

Hi Aiden, resize the pictures to 97kb or less and they should upload.
Also the truss rod may need more relief, the neck may have too much back bow.
Don't muck around with the truss rod too much unless you have a bit of experience. Don't force the allen key or you may snap the truss rod

[Aidan7250]

Nut hasent been changed getting pics ready

[Aidan7250]

I do have a little experience, not a pro at setting up my guitars

[Aidan7250]

http://imgur.com/tpm3g4O
http://imgur.com/0uLQZKB
http://imgur.com/Qc2HsNR

[wokkaboy]

hard to tell from the pics Aiden. The string action looks quite high above 12th fret. Then the bridge looks set quite low.
The neck should have a rake so the nut angles down from the body by a few degrees, does it have a rake angle ?