LP-1M with broken binding at neck join

[adam]

Hey Folks,

A complete LP-1M kit up for grabs. It's all good, except the binding at the neck join has chipped (see picture). I'm sure this can easily be repaired.

It's all yours for $150, including postage (anywhere in Australia).

Here's the link: http://www.pitbullguitars.com/shop/g...ding-at-joint/

[vh2580]

Sold - So guys what is the easiest way to remove an existing binding.

[bargeloobs]

/<\\/p>[]<\\/p>/Quote from vh2580 on October 12, 2014, 17:05
Sold - So guys what is the easiest way to remove an existing binding.

Really? What about making up a mixture of cream binding and glue and filling the chip IDK...

[ponch]

Or paint over it. Set the neck first, fill the gap and sand smooth

[WeirdBits]

Binding shavings and acetone goop mix will probably do it.

[stan]

not sure about acetone, the binding may dissolve/mix well, but if it doesn't set then it may even eat existing binding...

I would do something like ground up binding in something like 2 part epoxy

Or cut the existing off square and get a small block of binding and glue it in. Heat is usually used to make binding joins invisible, just dont over do it

[dingobass]

Weirdy is right, acetone is used to bond binding together.
I would shave some from an inconspicuous spot and experiment.