Hi guys, I'm putting together some templates and the artwork i've got is slightly borked. As a result, I need two measurements to make sure everything is to scale. On a PBG strat neck I need the width at the nut and at the widest part of the heel. If anyone has one about, I would greatly appreciate it if you could measure these for me. Cheers
'As long as there's, you know, sex and drugs, I can do without the rock and roll.'
Hey Pablo,
I'll try and remember to do this tonight and post it on this thread. From memory the nut is around 42mm wide but I'll confirm
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Thanks Wokka.
'As long as there's, you know, sex and drugs, I can do without the rock and roll.'
Hey Pablo,
the nut is 42mm wide and the neck heel is 54mm at the nut end and 56mm at the widest point (the bottom edge)
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Wokka = legend.
'As long as there's, you know, sex and drugs, I can do without the rock and roll.'
Posting Permissions
Reply With Quote