About time I actually put together a build thread.
This is my lefty LP kit - the plan is to do a satin black body, neck and sides with a painted front - colour yet to be revealed.
I wanted to do a wudtone type top finish but there were a few factors - there were some small knicks, bumps on the body in general. Also the flamed maple top was not centred properly, the division between the two sheets was off centre by about 10mm. Not lots, but enough to see instantly.
No problem - solid painted finish it is.
Primer/undercoat - upol automotive
a few coats rubbed back, nice and smooth.
Satin black goes on, also upol automotive, rubbed back as well:
In my haste to move things along - I applied to much black, too soon. The result was the the top coat crackled. Actually not a bad effect, but not what I wanted.
Could not do this deliberately if I tried:
Because too much sanding is not enough, that's what had to happen:
Black reapplied - taking my time this time. Currently at this stage:
more black to go...