I have a body with a gorgeous quilted veneer with binding around the edge. When i was preparing the body for finishing (some coats of thinned BLO then Tru-oil on top) I made an effort to remover any veneer from the binding to make it as clean as possible.
Two coats in, the veneer has swelled (I think) and is now covering the binding in some spots again. As per the second picture, the veneer isn't covering the binding everywhere, you can see some of the clean binding and it looks so good.
What's the best way to clean this up? Just keep sanding, through the finish around the binding, through the veneer and then refinish?