Hi Everyone,
I took a stab at my first wiring diagram. Sorry it’s messy. I took a diagram from Entwistle that shows partial phase of 1 humbucker on a DPDT switch. I combined 2 pups on a 4pdt switch, then figured a way to use DPDT for a master series/parallel switch.
The idea is: in parallel mode, both pups in parallel (normal) the pup selector works as normal and you have choice of normal or partial phasing both pups. In series mode, both pups in series, choice of both partially phased or not, and the pup selector isn’t really used - assume I’d just be in the middle position since this has both pups active.
Oh, wire colors are Entwistle, same as Seymour Duncan (Black +, Green -). Caps are .002uF on the phase switch, and .047uF on the tone pot. I don’t know which pup is bridge and neck, or if it matters . Any thoughts?
Thank you!