Artist LP Kit Build.

[Grubsta]

I do like the white the knobs i have are very similar in colour as well thanks Simon

[DrNomis_44]

I reckon the guitar will look great with black pickup rings, I love the contrast between the colour of the stain used on the back and the natural wood colour on the front, quite pleasing.

[wazkelly]

Hi Grubsta, looking good.

If mine, I would stick with the cream plastic bits that came with the kit as they are similar warm tones that should compliment stain colours and feel black may be too stark. Soaking in tea or coffee would darken them up a bit if that is what you prefer.

With DT stain running low best to make a start on the neck and if you run out maybe double up with extra intensifier coats. From memory it looks like a maple neck so that will probably need several more coats to dial in a similar colour to the body. Intensifier can add some colour, just not as much as the base stain.

Cheers, Waz

[Grubsta]

I've got a bit to think about here thanks for the advice guys very much appreciated.

With DT stain running low best to make a start on the neck and if you run out maybe double up with extra intensifier coats. From memory it looks like a maple neck so that will probably need several more coats to dial in a similar colour to the body. Intensifier can add some colour, just not as much as the base stain.

I have enough base stain to maybe squeeze 2 neck coats if i'm lucky so ill see how it goes. Yes indeed it is a maple neck i was hoping to make a start on it tomorrow.
I need to finish shaping the head stock as well.

[Grubsta]

And we have glue lines bugger. They didn't show in the initial coats but now they stand out like a pimple on a nose.

[Rabbitz]

Gold pinstripes?

Or possibly pinstripes to match the binding?

[Simon Barden]

I don't know how well it would work on the Dingotone (works OK with Tru-Oil), but I've been using coloured Sharpie pens to touch up the odd light spot on my ES-1/330 build. Find the nearest matching colour, draw on the finish and then smudge with a finger. Of course it will need some more clear over the top to protect it. I sometimes use two colours for a better match.

If it doesn't look right, a quick rub with turps or metho should remove the ink.

[Simon Barden]

And I now always treat any wood or veneer join as a probably glue line, so it's always worth going over the joins with a glue remover and a brush before you do anything else.

[wazkelly]

And I now always treat any wood or veneer join as a probably glue line, so it's always worth going over the joins with a glue remover and a brush before you do anything else.

Sad but true.

[Grubsta]

Thanks for the advice Simon ill have a play around and see how i go. Lesson learned here. When I started staining the top there were no signs of glue at all I think i put a little too much faith in the joins.