PBG Instruction Manual version 1.0

[Simon Barden]

Just starting to read through it.

Pg 5, list item 8. "Use a drill size slightly smaller than the screw. If you hold the drill over the shaft of
the screw you should still be able to see the threads on both sides".

As too small a drill bit will still allow you to see the thread on both sides. I suggest this is modified to something along the lines of:
"Use a drill size slightly smaller than the screw. If you hold the drill over the shaft of the screw, you should still be able to see the threads on both sides, but not the main part of the shaft".

Also on Pg 5 in the tools list

"Coping saw (only if your kits head stock came unshaped)" should really read "Coping saw (only if your kit's headstock came unshaped).

(Will do a pdf markup).

[Kirk3377]

I see nothing about the SH-1 headless guitar. I’m having installation problems with the bridge, and have nowhere to find information that will help me finish it. It would be a big help if that type of guitar had some type of instructions in the build guide. Thanks.

[Rabbitz]

I see nothing about the SH-1 headless guitar. I’m having installation problems with the bridge, and have nowhere to find information that will help me finish it. It would be a big help if that type of guitar had some type of instructions in the build guide. Thanks.

Ask your questions in the general forums.

We new and inexperienced builders are very lucky that there are a whole raft of experienced builders and luthiers who love to help out.

Just ask, no question is too simple or too hard.

[Cliff Rogers]

G'day.

I just spotted this on page 26.

Capacitors: .022 caps are used with single coil pickups and .047 with Humbuckers.

I reckon it should be the other way around.

[Browny1010]

Is there a problem with the site? Downloading the Instruction Manual does not work. Tried two devices.