Hello all. I need to finish repairs on my Epiphone Riviera before I start the builds on my GR and TLA kits which is requiring enourmous self dicipline and as I just want to get started on the new builds. Anyway, I have recently put together a wiring loom based on the Pitbull and SD Two Humbuckers to 2 Volume, 2 Tone and a 3 way Switch.. The problem is when I test the thing I'm getting no signal at the output jack. I have tried to trace back the fault and got the following results from the multimeter:
the pickups are supplying the required resistance to both volumes pots
Both volume pots are transferring the resistance to both tone pots
when I check the volume pots by placing either side of the multimeter on the input and output of each pot I get the correct resistance when dialled to ten and 0 resistance when dialed to 0
My Problem is:
I'm am not getting any resistance value from the output pins from both volume pots. Therefore no resistance being provided to the switch, or the jack and therefore no sound. I have checked the diagram and wiring 3 times and sure I've got it right.
Does anybody have any idea why this is happening?????
Reply With Quote
