1st Build IC-1

[grahamjohnston80]

The kit arrived today. Thank you PBG.
I'm really happy with it and can't wait to get started. I will wait until the weekend before doing a mock build and then the sanding can begin.

[Simon Barden]

All looking pretty good there.

[grahamjohnston80]

All looking pretty good there.

Yip. I'm very happy. The neck is a tight fit but I would rather that than too slack. I'll leave it until the weekend to settle and acclimatise before I do the proper mock build. Then again, I have a busy weekend coming up so it might have to wait until the following week.

[maxadudley]

Gorgeous!
Very jealous. If that was available at the time when I bought mine I would definitely have sprung for that.
Looks wonderful! Any thoughts on finish? Or is it too early to decide that?

[grahamjohnston80]

Gorgeous!
Very jealous. If that was available at the time when I bought mine I would definitely have sprung for that.
Looks wonderful! Any thoughts on finish? Or is it too early to decide that?

It was a lucky find. If it had come up a couple of weeks later it would've been too late as the original kit I ordered would've arrived.

I'm going to stain it with Dingotone. Kajirini Red (https://www.pitbullguitars.com/shop/...-karijini-red/)
I'm planning a colourless finish on the neck.

[Mosrite Slab]

Very nostalgic for me as I had an Ibanez one back in the early 80’s. I’ll watch with interest.

[grahamjohnston80]

Very nostalgic for me as I had an Ibanez one back in the early 80’s. I’ll watch with interest.

I've always wanted an Iceman and thought they were out of my price range. Can't wait to finally own one. I just hope that I do it justice!

[Trevor Davies]

Looks good. I cannot wait to the see the Karijini Red.
What wood is the body and neck?

[grahamjohnston80]

Looks good. I cannot wait to the see the Karijini Red.
What wood is the body and neck?

The body and neck are both mahogany. https://www.pitbullguitars.com/shop/...ustom-special/
I too can't wait to see how it turns out. I just hope I am patient and don't rush it.

[Trevor Davies]

When I did my FVB-4 with Dingotone, the intensifying coat took quite a while (nearly 2 weeks) to dry - it was winter and I had it in a room heated to 22 degrees C. That did test my patience a bit.