haha Sam, the spring goes below the pup so the screw head will be flush with the top of the pup. This allows the pup to raise when you loosen the screw.
The screw head should recess a little into the pup.
If the pup is still too high when screwed right down just get some pliers and cut the spring length
Last edited by wokkaboy; 07-08-2015 at 12:05 PM.
Current Builds and status
scratch end grain pine tele - first clear coat on !
JBA-4 - assembled - final tweaks
Telemonster double scale tele - finish tobacco burst on body and sand neck
Completed builds
scratch oak.rose gum Jazzmaster - assembled needs setup
MK-2 Mosrite - assembled - play in
Ash tele with Baritone neck - neck pup wiring tweaks and play in
Reply With Quote
