Made some progress recently, neck on, cavities shielded, pups wired and strings on.
Now I have a question about the locking nut on these kits. The high e string was hard down on the first fret so adjusted the small grub screw on top of the nut to get some clearance. Attachment 4328 Attachment 4329
There is now a gap of about 20 thou between the bottom of the nut and the end of the fretboard (can't get a good pic of it).
This is only on the treble side, the bass side is fine.
Do I need to put a shim in between or can I leave it as is?
Also have a question about the wiring. I followed this diagram
Only thing I needed to change was add a ground wire between the tone pots as the adhesive on the shielding tape wasn't as conductive as it could be.
Everything appears to work fine, however when the pup selector is set to bridge only and the neck tone is 'up' there is no output.
Is this how it's supposed to work? Tried to check on their site for specifics (switch must be in this position, etc) and couldn't find this diagram listed, just my luck.
Any wisdom will be greatly appreciated.
Reply With Quote