So these bad boys turned up today woohoo!!
Now from what the diagram that came with them says, the red is the slug coil start, black is slug coil finish, green is screw coil start and white is screw coil finish. The 2 finish wires (black and white) have heat shrink around the ends, do I need to remove them? Where do I go with this? Will these wires mean that wierdys diagram is the same even though it's based off an entwhistle pickups?
There is also a bare wire which I would assume is ground?
Also what wore do I use whilst wiring, can I just use the stuff that came in my kit or is there a better wire to use?
Reply With Quote