So a long awaited update. I did some work and I ended up sanding at the neck heel. Worked to perfection. The neck is now at the right height and angle for the floyd rose. Following that, a few chocks had been placed for the locking nut, which now also fits perfectly and to perfection. Head stock had been cut out using the bandsaw at work. (I work in a butchery) shhhh. Looks good but haha. 2 coats of primer filler were applied and then sanded back with 120 grit. Then a further 5 coats of primer filler were applied and will be sanded back with a fine sandpaper. My guitar surprisingly was rather flat. So not a great deal of preparation was needed. The primer is now curing to make sure it's set hard ready for paint. Which has decided to be a polar white with a black pinstripe about 8mm thick around the outside edge. If I knew how to post photos on my phone then you could all see the process. So they will be up later instead. Cheers, Kurt.