Veneer headstocks

[wokkaboy]

Hey BG, yeah I've done tons of headstock veneers and it gives the axe a nice personal touch.
First I trace the shape of the headstock paddle onto the veneer and make sure the veneer will cover the whole paddle. Trim the veneer down with a sharp knife leaving a bit of excess so it can move around a bit while gluing and still cover the whole paddle. Clean the surface of the headstock with a water damp cloth. Once its dried smear titebond onto the headstock face, and try smooth out any blobs of glue as these will cause lumps in the veneer. I place the veneer onto the headstock. Prior have a flat piece of scrap wood that will cover the area and you will need at least 8-10 clamps, more the better. I start with a clamp at the top end so the scrap wood is butt up to where the curve starts. Then I squeeze in a piece of dowel to keep the curved section of the veneer held down.
Then leave to dry for at least 3 or 4 hours. Make sure the veneer covers ALL of the headstock and it is flush or past where the fingerboard starts, important while the glue is wet.
Then carefully remove the clamps. Draw your headstock shape and cut it.
Then sand as usual.
Drill out the tuner holes. This I do starting with a small drill say 2.5mm from below to the top of the veneer to locate the holes, try for the centre. Then from above I use say 5mm drill and drill slowly in reverse, as the veneer tears out very easily. Then step up the drill sizes to slowly drill out to the tuner hole size.
Same with the truss rod hole, you have to take a guess where it is so take a photo before the veneer goes on. I use a small drill and then once its located use one of those small art blades to cut out the shape.
This is delicate work as the veneer is probably less than 1mm thick.
I also face the veneer onto the bench, once dried and you can trim excess off with a sharp blade.
Good luck !
If you aren't certain of the process I can help you out on a weekend or weeknight. Its worth having enough clamps to have no spaces between the clamps so you may need a dozen or so on a bass headstock. You will have to leave it at my workshop while it dries or take it home and return clamps, or bring whatever clamps you have.
I've stuffed up quite a few veneers in the learning process and had to sand it back and start again. Have you got enough veneer for 2 veneers in case?

[sgriffiths]

Once its dried smear titebond onto the headstock face, and try smooth out any blobs of glue as these will cause lumps in the veneer. I place the veneer onto the headstock. Prior have a flat piece of scrap wood that will cover the area and you will need at least 8-10 clamps, more the better.

I remember reading a discussion about different sorts of titebond and some being better than others, which one would you choose? Is their liquid hide any good?